T
U
46
16-CLEANING
Only by properly servicing and cleaning the product is it possible to ensure its safety and correct operation.
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected.
Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certified good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Brazier cleaning
Before ignition, always clean the “T” brazier and remove any ash or incrustation from it that might obstruct the air flow holes, paying
attention to hot ash. In the case of ignition failure, or if fuel in the tank runs out, unburned pellets may accumulate in the brazier. Always
empty the residue in the brazier before each start-up. Only if ash is completely cold may a vacuum cleaner be used to remove it. In this
case, use a suitable vacuum cleaner to remove small sized particles.
EXAMPLE OF A CLEAN BRAZIER
EXAMPLE OF A DIRTY BRAZIER
Summary of Contents for EGO 2.0 AIR OYSTER
Page 1: ...EN PELLET STOVE EGO 2 0 AIR OYSTER Instructions in English INSTALLATION GUIDE...
Page 58: ......
Page 59: ......
