MCZ EGO 2.0 AIR OYSTER, Installation Manual

Page: 49 / 60

w
j
k
x
47
16-CLEANING
Technical Dept. - All rights reserved - Reproduction is prohibited
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE SAFE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY RESTART.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door
gaskets (ceramic fibre cord).
CLEANING THE AIR FILTER (where installed)
The stove is standard supplied with a “j” 048/60 adapter fitted to the air intake pipe for ducting. The wire mesh air filter “w” you will find
inside the instructions bag has the purpose of preventing dirt from entering the motor body and the internal sensor. To fit it, adapter “j”
must be removed by loosening clamp “x” and removing the three screws “k”. Therefore, in the event filter “w” is installed, cleaning must be
performed. It is recommended to check that the filter is clean every 15/20 days. If needed remove fluff or the material that has deposited
on it.
Inspection and cleaning are required more frequently if there are pets in the house.
Simply remove the filter to clean. To clean it use a brush or a damp cloth or compressed air. Set it back in place by simply pressing it
(interlocks).
The filter is made of metallic mesh and is soft and flexible to the touch therefore, when cleaning, be careful not to
crush or damage it. In the event of breakage it must be replaced.