IOMM AGZ-5
AGZ 026B through 130B
69
Stop/Reset Key
- Press this key to stop the motor when it is running (uses the programmed
deceleration rate). This key will also reset an alarm that has tripped.
Potentiometer
-Allows an operator to directly set the motor speed when the potentiometer is
enabled for output frequency control.
Potentiometer Enable LED
- ON when the potentiometer is enabled for value entry.
Parameter Display
- A 4-digit, 7-segment display for parameters and function codes.
Display Units, Hertz/Amperes
- One of these LEDs will be ON to indicate the units associated
with the parameter display.
Power LED
- This LED is ON when the power input to the inverter is ON.
Function Key
- This key is used to navigate through the lists of parameters and functions for
setting and monitoring parameter values.
Up/Down (
1
,
2
)
Keys
- Use these keys alternately to move up or down the lists of
parameter and functions shown in the display, and increment/decrement values.
Store (
) Key
- When the unit is in Program Mode and you have edited a parameter value,
press the Store key to write the new value to the EEPROM.
Keypad Navigational Map
The CR100 Series inverter front keypad contains all the elements for both monitoring and
programming parameters. The diagram below shows the basic navigational map of parameters
and functions.
Summary of Contents for AGZ026BS
Page 103: ...IOMM AGZ 5 AGZ 026B through 130B 103...
Page 104: ...104 AGZ 026B through 130B IOMM AGZ 5...
Page 105: ......
