iScout® System User’s Manual
20
© McQ Inc 2008
7.
Rotate the
Battery/Switch Cover
clockwise to the mark on the case to apply power
(Figure 3-5).
8.
Remove the PIR lens cover and observe the LED through the lens (Figure 3-6). For the
first twenty seconds it will be solid red. When the sensor completes its internal test the
LED will either flash
RED
or
GREEN
and then it will go out.
a.
Flashing red with a pattern of flashing forty times at twice a second, (it will light
RED
twice each second for twenty seconds), indicates that the internal test was
successful but that the power-on
Configuration message
was not acknowledged
by an HHPM. The unit is functional but the communications link has not been
verified. The HHPM settings should be checked to ensure
Bluetooth (WMR)
is
selected and that a Bluetooth connection has been verified with a popup message
on the HHPM. Also check to make sure that the WMR is completely charged.
b.
Flashing
GREEN
with a pattern of flashing 20 times at once each second, (it
lights
GREEN
every second for twenty seconds and then goes out), indicates a
successful transmission and receipt of the power-on
Configuration message
.
9.
After the LED goes out, the unit should have sent its
Status
and
Configuration
messages
to the HHPM. If the sensor is not listed in the
Device List
, the operator cannot
communicate with the unit and any configuration attempts will not work. Using the
Discover Devices
option
from the
Devices menu
, the HHPM should receive a response
from the sensor and populate its
Device List
with the new sensor. The operator can also
Figure 3-5: Battery Switch Cover
Rotated to ON Position
Figure 3-6: PIR Lens Cover
(observe LED indication through
the lens)
