MCL nanoSwitch, Installation Manual

Page: 25 / 52

6-1
5
nanoSwitch Installation Guide System Wiring
Power Connections
On the rear of the frame there is a connector panel with sevent sockets and plugs.
AC Power is connected to the exchange through an IEC power connector The supplied line
socket must be used as this fits the retaining clamp.
DC Power is connected through the supplied green connector.
A serial printer can be connected to the nanoSwitch. The wiring for the port is the same as on a
Personal Computer. The manual for the printer will give the required wiring and connections.
The serial printer is set up as 9600baud, 8-bits and 1 stop bit and CTS/RTS handshaking.
An RJ45 ethernet socket is also provided. This will be available with C4025 Processor card.
Extension and External Wiring
The connection to the ship’s wiring is through the internal MDF.
The “screwless” connectors are designed to take up to 2.5mm cables and just require a flat blade
screwdriver (blade size 2.5mm x 0.4mm) to capture the wire.
The drawing on the next page gives more detail.