PBXgateway II Quick Installation Guide
24
Installation Environments
Introduction
This section of the manual provides the necessary information to
configure the PBXgateway II using the Management Interface (MI).
Note: The units are programmed at the factory with “default” settings
providing basic parameters to accommodate most network
environments
.
Which type(s) of
Remote Client
device(s) do you
have?
You must first determine which type of Remote Client device(s) are to be
deployed and the Connection Protocol over which these devices will
communicate.
Use the chart on page 11 of this document to configure the system.
Which type of
Network Device(s) do
you have?
It is also necessary to identify which type of network access device and
the type of network (circuit or packet-based) over which these devices
will communicate.
Table 3:
Installation Environments
MCK Client Devices
Connection Protocol
Network Devices or
Connection
See
Page…
Multi-User
Branch Office EXTender
6000
RVP_Direct (WAN port -
synchronous-serial)
CSU/DSU,
Sync-TA,
FRAD
25
Branch Office EXTender
6000
RVP_Direct (WAN port -
asynchronous)
TA 26
Branch Office EXTender
6000
RVP_IP (LAN port)
10/100 BaseT
Ethernet connection
30
Single-User
EXTender 1000
PSTN
Standard Tele-
phone Line
50
EXTender 3000
ISDN
ISDN BRI
Line
51
EXTender 4000
RVP_IP (LAN Port)
10/100 BaseT
Ethernet connection
31
Mobile EXTender
None: Uses PBX trunks
-
32