Max Phantom 2000, Installation And Owner'S Manual

Page: 37 / 46

3 5
Adjustments
release handle clamp
Tighten the Adjustment bolt until desired result is achieved.
The release handle clamp has been factory adjusted and
SHOULD NOT need any adjustment.
IMPORTANT: The red handle MUST BE FIRMLY secure in the
HORIZONTAL position .
NOTE: When limit tabs are already set and the release handle is put
back in the secure position but the gate is NOT in the full open or close
position, the operator will automatically re-align the gate’s open and
close tabs. No readjustment is necessary .
After Release Handle Clamp is in the SECURE HORIZONTAL
position:
Pull the arm. NO slippage should occur.
If it does, readjust.
Adjustment
Bolt
factory set bolt
DO NOT adjust
adj
ust
bo
lt
for
firm
grip
Arm
Adjustment:
Re-Attach to Operator:
Limit Pin
Limit Tabs
Slot
Release Handle Clamp
Limit pin MUST fit into slot in bottom of
release handle clamp directly under the
arm when reattaching arm to operator.
IMPORTANT: The arm MUST NOT slip
when the gate is cycling or the gate OPEN
and CLOSE limit positions will NOT be
LEARNED . Gate speed will remain slow if
gate positions are NOT learned.
Release Handle Clamp MUST be
HORIZONTAL when FIRMLY secured.
NO