41
10) Plug the coax cable into the coax adaptor attached to the back half of the console (Figure K).
11) Plug the side of the controller cable labeled To Console into the C-Safe port near the top of the UCB (Figure L).
12) Route the TV power and net wires through the console. These wires do not plug into the console, but should protrude from the top and
bottom opening of the console. There should now be 4 wires protruding from the top of the console (coax, power, net, and controller wires)
(Figure M).
13) Use the 4 screws removed in Step 4 to re-attach the 2 halves of the console. Be careful not to pinch any of the TV wiring.
14) Install the bracket to the console using 4 screws (Figure N).
15) Install the console back onto the console mast and secure it with 5 screws (Figure O). Make sure to make all wiring connections including
the net wire (if using wired internet), power wire and coax cable. Tuck all the wiring into the console or mast to prevent any pinching.
16) Plug the power wire into the back of the TV (Figure P).
FIGURE K
FIGURE L
FIGURE M
FIGURE N
FIGURE o
FIGURE P
BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.7
PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - UNIVERSAL 3x CoNSoLE
- CoNtINUEd
