Matan The SprinterB, User Manual

Page: 56 / 158

The Utilities Menu Around the Windows
6-16 Sprinter User's Manual
Group Box Screen
Component Description
Units M/mm
feet/inch
Shift and Delay
in dots
Units of measure
Color Order Choice of the printing color order, according to the order in
which the Ribbons are installed on the printer.
Temparature °C
°F
Units of measure – temperature
TIFF LUT coeff: Enables you to adjust the density percentage of each color
station.
For example, entering 0.9 on the 1
st
color station, will decrease
that color’s density by 10%. Conversely, entering 1.1 on the 1
st
color station, will increase that color’s density by 10%.
Head
Resistance Not yet implemented.
Grey level
adjustment Enable Check this option to enable the grey level adjustment feature.
For all 50 dpi TIFF files that are to be printed.
Edit Click this button to access the Grey Level dialog box.
Browse Click this button to browse for an existing Grey Level file.
General Pressure sensor When activated, if there is a change of air pressure greater
than ± 0.5Bar, an error message appears, informing you of the
status.
We recommend you to keep this feature activated. If however,
the fault will take time to correct, and you can safely continue
working until then, you can deactivate this option on a
temporary basis.
Y resolution 400 x 200 dpi resolution only, implemented.
Encoder
Division
Related to the main pulling system.
See the Note at the end of this table.
Main motor
coefficient
Related to the main pulling system.
See the Note at the end of this table.
OK Click this button to acccept your settings and close the dialog
box.
Cancel Click this button to close the dialog box without saving your
settings.
Help Click this button to access the online Help.
The Encoder Division and Main Motor Coefficient parameters must be checked
immediately after the software installation. This is done through the Preferences
dialog box (see the Setting the Preferences section).