Matan The SprinterB, User Manual

Page: 65 / 158

Preparing Your Printer for Printing Preliminary Preparations for Printing
Sprinter User's Manual 8-5
11. With the split in the B
RAKE
located at each end of the holders facing
upward, place the S
UBSTRATE
R
OLL
back into S
UBSTRATE
R
OLL
S
UPPORTS
.
12. Relocate the L
OCKING
P
INS
.
13. Cut off the first meter of the roll to prevent dirt from reaching the P
RINT
H
EADS
, Then cut a diagonal piece as illustrated in Figure 8-6.
Figure 8-6: Substrate Roll
14. Feed more than a meter of the S
UBSTRATE
between the S
UBSTRATE
G
UIDING
R
OLLER
and the sprung S
CRAPER
, under the I
ONIZOR
, and then
under the S
TICKY
R
OLLER
.
15. Thread the substrate toward the front of the printer, on top of the
rubber rollers and under the G
UIDING
R
OLLERS
, as illustrated in
Figure 8-7. Ensure that the S
UBSTRATE
is placed within the limits of the
ribbons’ width and is not protruding over the edges on either side, more
than 915mm.
Figure 8-7: The Substrate and Ribbon Path