Rad-67
Chapter 9: Service and Maintenance
www.masimo.com
94
Masimo
Power-On Self-Test
To conduct a Power-On Self-Test
1.
Power on the device by pressing the home button.
2.
Upon powering on, the device should emit a tone and the Masimo logo should
display.
Note:
If the
Rad-67 does not pass the Power-On Self-Test, a system failure technical alarm
will be activated. See
Chapter 7: Troubleshooting
on page 67.
Touchscreen Function Test
To conduct a Touchscreen Function Test
1.
Connect the Rad-67 to AC power.
2.
Perform the gestures outlined in
Using the Touchscreen Interface
on page 30.
Maintenance
Battery Operation and Maintenance
The Rad-67 includes a lithium ion rechargeable battery.
Before using the Rad-67 without the AC power connected, check the battery status indicator
and ensure that the battery is fully charged. See
Battery Charge Status Indicator
on page
To charge the Rad-67 battery, refer to
Initial Battery Charging
on page 27.
Note:
When battery run time is significantly reduced, it is advisable to completely discharge
and fully recharge the battery.
Run Time for Rad-67
The following table outlines the estimated minimum run time of the battery in the Rad-67.
The time estimates are based on a fully charged battery.
Time estimates are also based on specific operating modes.
For optimal battery run time, configure the device to automatically adjust the brightness.
See
Brightness
on page 52.
Configuration Operating Mode
Minimum run time (Est.)
Rad-67
Not connected to AC power
All connectivity options turned off
Brightness level set to level 3
6 hours
