MX Comp + ETA
8/45
Warning
INSTALLING THE V-BRAKE SYSTEM
Installing the brake system is a very
delicate operation that must be carried out
at our specialised service centres only.
Marzocchi does not guarantee the
installation and accepts no liability for
damage and/or accidents arising from a
wrong installation.
The installation of the brake system
must be carried out following the
instructions of the brake system
manufacturer. Improper installation can
be dangerous for the rider.
Use only brake systems in accordance with
the fork’s specifications.
If the fork does not come standard with
V-brake mounts, after removing the
cable guide (A) and the disk brake
mount cap (B), install the adapter (A)
and the bolt (D) on both legs, check that
the adapter is correctly oriented as
shown and tighten the bolt to the
recommended tightening torque (11±1
Nm).
On the thread of bolts (D) a special
anti-unscrewing treatment has been
applied; as a result, the removed bolts
cannot be re-used as they lose such
treatment.
Summary of Contents for MAX COMP + ETA - 105
