MX Comp + ETA
37/45
Assembling
FILLING WITH OIL
· Put the fork in the vice in vertical position.
· Lower the crown-stanchion unit on the
arch-slider assembly.
· Prepare the quantity of oil to pour into the
fork leg (see table).
· Pour roughly 1/3 of the oil required into
each stanchion, then pump the fork a few
times to remove any traces of air.
· Pour the rest of the oil in.
· Lower again the crown-stanchion unit on
the arch-slider assembly.
· Wait for a few minutes and check the
volume of the air (h); if necessary refill to
the right level.
A lower or higher volume of air, or a
type of oil other than the recommended
type can change the behaviour of the
fork in every phase.
Summary of Contents for MAX COMP + ETA - 105
