MX Comp + ETA
24/45
Disassembling
REMOVING THE GUIDE BUSHES
Use the special extractor to remove the
guide bushes. Do not use other tools.
Fit the aluminium bush (
A
) to the extractor
keeping the small diameter side towards
the edge opposite to the striker.
Fit the extraction washer (
B
) with a white
finish to the extractor.
During use, remove the non-used
washer from the extractor.
Remove first the top bushes, then the
bottom bushes.
Fit the extraction washer keeping the blunt
side towards the threaded grubscrew (
C
)
fixed crosswise on to the main rod as
shown.
The slot in the rod lets the extraction
washer swing inside the rod itself.
Insert the extractor in the arch-slider
assembly from the side of washer (
B
) as
shown.
The slot in the extractor rod will let the
washer pass underneath the bush to be
extracted.
Summary of Contents for MAX COMP + ETA - 105
