CYLINDER HEAD COVER
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect breather hose and PCV valve from head cover.
3) Remove high-tension cords.
4) Remove cylinder head cover (1) with cylinder head cover gas-
ket (2) and O-rings (3).
INSTALLATION
1) Install O-rings (2) and cylinder head cover gasket (1) to cylinder
head cover (3), after applying sealant to part “A” as shown in fig-
ure.
“A” Sealant: 99000-31110
NOTE:
Be sure to check each of these parts for deterioration or
any damage before installation and replace if found defec-
tive.
2) Install cylinder head cover to cylinder head and tighten cover
bolts to specified torque.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
NOTE:
When installing cylinder head cover, use care so that cylin-
der head cover gasket or O-rings will not get out of place
or fall off.
3) Install high-tension cords (1).
4) Connect PCV valve and breather hose to head cover.
5) Connect negative cable at battery.
6A1-10
ENGINE MECHANICAL
SH410