9) Install pulley (1) and tighten pulley nut (2) with holding shaft us-
ing hexagonal box wrench to specified torque.
Tightening Torque
(a): 113 N
.
m (11.3 kg-m, 81.5 lb-ft)
10) Install rectifier (1). Curl stator leads (2) as shown in figure.
CAUTION:
When installing rectifier, check to confirm that stator
leads have enough clearance with cooling fan
blades.
Tightening Torque
(a): 2.0 N
.
m (0.2 kg-m, 1.5 lb-ft)
11) Install brush holder cover (1) to brush holder (2).
12) Place IC regulator (1) together with brush holder (2) horizon-
tally on rear end frame (3).
13) Install 5 screws.
Tightening Torque
(a): 2.0 N
.
m (0.2 kg-m, 1.5 lb-ft)
14) Install rear end cover (1).
Tightening Torque
(a): 3.7 N
.
m (0.37 kg-m, 3.0 lb-ft)
15) Install insulator (2) and tighten B terminal inner nut (3) to speci-
fied torque.
Tightening Torque
(b): 3.6 N
.
m (0.36 kg-m, 3.0 lb-ft)
CHARGING SYSTEM
6H-21
SH410
