3-14
56RH0-74E
If the “PUSH” indicator light blinks and
the engine cannot be started
Your keyless push start system remote
controller may not be sensed as being
within the interior workable area. Try again
after checking that you have the remote
controller with you. If the engine still can-
not be started, the battery of the remote
controller may be discharged. You must
then use the following method to be able to
start the engine.
56RH00302
1) Make sure that the parking brake is set
fully.
2) Manual Transaxle – Shift into “N” (Neu-
tral). Hold the clutch and brake pedals
fully depressed.
Auto Gear Shift – Shift into “N” (Neutral)
and fully depress the brake pedal. Hold
the brake pedal fully depressed.
3) The “PUSH” indicator light in the instru-
ment cluster will come on. Press the
engine switch (1).
4) Within about 10 seconds of blinking of
the “PUSH” indicator light in the instru-
ment cluster, touch the engine switch
with the lock switch end of the remote
controller (2) for about 2 seconds.
NOTE:
• If you still cannot start the engine after
several attempts using the above
method, there may be a problem else-
where, such as a low battery. Contact an
authorised Maruti Suzuki workshop for
inspection.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the “PUSH” indicator
light is blinking.
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing range. Please contact an autho-
rised Maruti Suzuki workshop for the
customization.
• If the battery of the remote controller is
about to become completely discharged,
the keyless push start system remote
controller battery consumption indicator
in the information display will come on
for a few seconds when the ignition
mode is changed to “ON” by pressing
the engine switch. For details on replac-
ing the battery, refer to “Keyless push
start system remote controller / keyless
entry system transmitter (if equipped)” in
“BEFORE DRIVING” section.
Returning the ignition mode to
“LOCK” (OFF)
NOTE:
Certain problems like a fault in engine sys-
tem may prevent the engine switch from
going back to “LOCK” (OFF) mode. If this
happens, have the vehicle inspected by an
authorised Maruti Suzuki workshop after
doing the following:
• Lock the doors using the key to prevent
theft. (The request switches and the key-
less push start system remote controller
cannot be used to lock them.)
• Disconnect the negative cable from the
battery to prevent discharge.
“LOCK” (OFF) mode reminder buzzer
If the driver’s door is opened without
returning the ignition mode to “LOCK”
(OFF) by pressing the engine switch, a
buzzer sounds to warn you of this condi-
tion.
• If you open the driver’s door after press-
ing the engine switch to change the igni-
tion mode to “ACC”, the interior buzzer
beeps intermittently.
• The buzzer will stop sounding if you then
push the engine switch twice, thus bring-
ing it back the ignition mode to “LOCK”
(OFF).
NOTE:
(1)
(2)
EXAMPLE
