Martin Imager Series, Operator'S Manual

Page: 38 / 84

38 DMX Controller operation
DMX Controller
operation
The Imager may be programmed and operated with any lighting control
device that is compatible with the USITT DMX standard. This section
describes how to operate the system with a controller.
See the appropriate section for specific control values for your Imager
model:
• “Imager 04 DMX-Gobo Wheel” on page 71.
• “Imager 04 DMX-Gobo Wheel with moving-mirror fitted” on page 72.
• “Imager 01 DMX-Gobo” on page 74.
• “Imager 01 DMX-Gobo with moving-mirror fitted” on page 76.
Connecting a DMX control device
Connect a data cable from the Imager J-Box to the control device’s data
output. If the control device does not have an RJ-45 socket then you may
need to purchase or wire an XLR-to-RJ45 converter. For wiring information
see “Creating a data link” on page 16.
Set the appropriate DMX mode
There are two DMX modes:
• DMX mode 1 uses 9 channels and does not allow fine adjustment of
movement and effects.
• DMX mode 2 , which is the default, uses 12 channels and allows fine
adjustment of movement and effects.
The mode that is used is specified using the Profile menu in the control
panel (see “Control menu structure” on page 66.