MARMON ANGELO PO ACT.O, Technical Manual

Page: 41 / 184

Copyright by Servizio Clienti ANGELO PO Spa
41
“Oven Type” configuration procedure:
The oven configuration procedure is carried out after replacing one of the following
components: CPU board, Power Board, Inverter, Combustion Control and Display . It
is used to make the various boards communicate with each other and to select the correct
operating parameters of the oven.
It is performed as follows:
- enter the Service menu
-
select the “
Oven Type
” item
- select the type of oven
- wait the end of the procedure and check the list of peripherals, comparing it with the
previous table (Tab.1).
- If the E20 alarm appears during the procedure, reset by pressing the reset key and
repeat the procedure by pressing the “repeat configuration” key. If the problem
persists, check the detected elements and the wiring of the undetected
components.
- If, at the end of the procedure, the screen does not correspond to the table below,
check the wiring and repeat the configuration by pressing the “repeat configuration”
key.
- If the configuration is
correct (the screen corresponds to the table) press “OK”.
See table 1 above .
Automatic Washings
: if activated, displays the automatic washings in the “AUTOMATIC
WASHING” menu.
Green is activated (see chapter 6.)