19
Start the vehicle’s engine with the
ignition key (while the engine is
running the parking lights and the
LED should be flashing). If they are
not you need to recheck your
tachometer wire connection.
Step 4
START
Press and hold the valet switch.
When the RPM level is learned, you
will hear a long chirp/beep and the
LED will be on steady for 2 seconds.
Step 5
Turn off the ignition to stop the
engine.
Step 6
Press the (*) button on the
transmitter twice to start the vehicle.
If everything is correct, the engine
will crank and fire without over-
running or under-running the starter.
If all things seem correct, press the
(*) button twice to stop the engine
running. If a cranking problem is
noticed, you may need to adjust the
crank detection feature (follow the
procedure on page 20).
Step 8
Press the lock button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and will get 3 parking
light flashes for confirmation.
Step 7
Tachometer Detection Programming (continued)
M6A-IM 3/10/05 2:43 PM Page 19