Manitou MLT625-75 H S1-E3, Operator'S Manual

Page: 43 / 160

1-19 1-19
LAYING A HIGH LOAD ON STABILIZERS LAYING A HIGH LOAD ON STABILIZERS
- - Raise and extend the jib (1) (2) until the load is above the elevation (fig. G9), while Raise and extend the jib (1) (2) until the load is above the elevation (fig. G9), while
monitoring the longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR monitoring the longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR
HANDLING A LOAD: C HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE ). ).
- - Position the load horizonta Position the load horizonta lly and release it by lowering and retracting the jib (1) ( lly and release it by lowering and retracting the jib (1) ( 2) to 2) to
position the load correctly (fig. G10). position the load correctly (fig. G10).
- Release the forks by alternating retracting and raising the jib (3) - Release the forks by alternating retracting and raising the jib (3) (fig. G11). (fig. G11).
- If possible, set the jib in transpor - If possible, set the jib in transpor t position without moving the lift truck. t position without moving the lift truck.
1 1
2 2
3 3
G8 G8
1 1
2 2
G7 G7
1 1
2 2
G9 G9
3 3
G11 G11
1 1
2 2
G10 G10
H - TAKING UP AND LAYING DOWN A SUSPENDED H - TAKING UP AND LAYING DOWN A SUSPENDED LOAD LOAD
WARNING: Failure to follow the above instructions may lead the lift WARNING: Failure to follow the above instructions may lead the lift truck to loose stability and over truck to loose stability and over turn. turn.
MUST be used with a lift MUST be used with a lift truck equipped with an operational hydraulic movement cut-out device. truck equipped with an operational hydraulic movement cut-out device.
CONDITIONS OF USE CONDITIONS OF USE
- The length of the sling or the - The length of the sling or the chain shall be as shor chain shall be as shor t as possible to limit swinging of the load. t as possible to limit swinging of the load.
- Lift the load ver - Lift the load ver tically along its axis, never by pulling sideways or lengthways. tically along its axis, never by pulling sideways or lengthways.
HANDLING WITHOUT MOVING THE LIFT TRUCK HANDLING WITHOUT MOVING THE LIFT TRUCK
- - Whether on stabilisers or on tyres, the latera Whether on stabilisers or on tyres, the latera l attitude must not exceed 1 % and the longitudinal attitud l attitude must not exceed 1 % and the longitudinal attitud e must not exceed 5%, the e must not exceed 5%, the
bubble of the level must be held at “0”. bubble of the level must be held at “0”.
- Ensure that the wind speed is not - Ensure that the wind speed is not higher than 10 m/s. higher than 10 m/s.
- Ensure that there is no - Ensure that there is no one between the load and the lift tr one between the load and the lift tr uck. uck.
I - TRAVELLING WITH A SUSPENDED LO I - TRAVELLING WITH A SUSPENDED LO AD AD
- - Before moving, inspect the terrain in order to avoid excessive sl Before moving, inspect the terrain in order to avoid excessive sl opes and cross-falls, bumps and pot opes and cross-falls, bumps and pot holes, or soft ground. holes, or soft ground.
https://www.forkliftpdfmanuals.com/