Manitou MLT625-75 H S1-E3, Operator'S Manual

Page: 40 / 160

1-16 1-16
overloaded, replace the load in the place from which it was taken. overloaded, replace the load in the place from which it was taken.
- - If possible lower the load with If possible lower the load with out shifting the lift truck. Lift the jib (1) to releas out shifting the lift truck. Lift the jib (1) to releas e the load, e the load,
retract (2) and lower the jib (3) to retract (2) and lower the jib (3) to bring the load into the transpor bring the load into the transpor t position (fig. F4). t position (fig. F4).
- - If this is If this is not possible, back up not possible, back up the lift truck (1), manoeuvring very gently and carefully to the lift truck (1), manoeuvring very gently and carefully to
release the load. Retract (2) and lower the jib (3) to bring the load into the transpor release the load. Retract (2) and lower the jib (3) to bring the load into the transpor t position t position
(fig. F5). (fig. F5).
2 2
1 1
2 2
F3 F3
1 1
3 3
2 2
F4 F4
1 1
2 2
3 3
F5 F5
LAYING A HIGH LOAD ON TYRES LAYING A HIGH LOAD ON TYRES
- Approach the load in the transpor - Approach the load in the transpor t position in front of the pile (fig. F6). t position in front of the pile (fig. F6).
- Put the handbrake on and set the forward/reverse selector to neutral. - Put the handbrake on and set the forward/reverse selector to neutral.
- - Lift and extend the jib (1) (2) until the load is above the pi Lift and extend the jib (1) (2) until the load is above the pi le, while keeping an eye on the le, while keeping an eye on the
longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR HANDLING A longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR HANDLING A
LOAD: C - LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE). If necessary, move LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE). If necessary, move
the lift truck (3) forward (fig. F7), driving very slowly and carefully. the lift truck (3) forward (fig. F7), driving very slowly and carefully.
- - Place the load in a horizontal position and lay it down on the pile by lowering and retracting Place the load in a horizontal position and lay it down on the pile by lowering and retracting
the jib (1) (2) in order to the jib (1) (2) in order to position the load correctly (fig. F8). position the load correctly (fig. F8).
- - If possible, release the fork by alternately retracting and raising the jib If possible, release the fork by alternately retracting and raising the jib (1) (fig. F9). Then set (1) (fig. F9). Then set
the forks into transport position. the forks into transport position.
- - If this is not If this is not possible, reverse th possible, reverse th e lift truck (1) very slowly and carefully to e lift truck (1) very slowly and carefully to release the release the
forks (fig. F10). Then set them into transpor forks (fig. F10). Then set them into transpor t position. t position.
F6 F6
F7 F7
https://www.forkliftpdfmanuals.com/