![background image](http://html.mh-extra.com/html/mandc/gentwo-pma1000/gentwo-pma1000_instruction-manual_682431010.webp)
9
PMA1000/PMA1000L | 1.00.00
www.mc-techgroup.com
2.4 Safety instructions
Please follow these safety directions and instructions regarding installation, commission-
ing and operation of the PMA1000/PMA1000L.
Qualified
personnel
Installation, commissioning, maintenance, inspections and any repairs
of all M&C products and components must be carried out by quali-
fied personnel in compliance with the current regulations.
Install the device only in protected areas, sheltered from sun, rain and moisture.
Operate the device only in the permitted temperature and pressure ranges. For details
please refer to the technical data on page 17 chapter ‘Technical data’ .
Don‘t repair or maintain this product without M&C‘s specific maintenance- and service
instructions.
When replacing parts, use only original M&C spare parts.
Pull Main
Plug!
If there is any indication that safe operation of the
PMA1000/PMA1000L is no longer possible, turn off the power and
disconnect the device from the power supply immediately.
Then protect the defective device against accidental switch-on and mark it clearly as
defective.
2.5 Working on electrical and electronic devices
Only qualified and authorized personnel are permitted to work on equipment which op-
erates on 115 or 230 VAC supply voltage. Please be sure to observe the generally accepted
engineering standards and all of your national and local regulations.
Note
Before connecting the device, please make sure that the supply
voltage matches the specified voltage on the product label.
High
Voltage!
Protect yourself and others against damages which might be caused
by high voltages. Disconnect the power supply before opening the
device for access. Make sure that all external power supplies are
disconnected.
Please make sure to take appropriate precautions even by working on unplugged or
low-voltage devices. Unplugged devices need to be properly grounded to prevent dam-
age to internal electronics from electrostatic discharges (ESD).