Malaguti Drakon 50, Manual

Page: 145 / 303

22
3
INSTRUMENT AND CONTROL FUNCTION
ENGLISH
B2
V
A2
B3
A3
B1
A1
To remove the seat
Loosen screw V , raise the seat and pull the seat out from the rear
side of the vehicle.
To install the seat
Insert projections B1-B2-B3 in the relevant fasteners A1-A2-A3
and tighten screw V .
Make sure the seat is properly secured before riding.
SEAT
Before operating the sidestand, make sure the ground is suitably
flat and stable. Soft soil, gravel or asphalt softened by heat, for
instance, can cause the vehicle to fall and be seriously damaged.
If you are parking on a slope, make sure the rear wheel is parked
on the lower side.
To operate the sidestand, hold the handlebar with both hands and,
at the same time, press your foot onto the lever to “guide” the
sidestand to its fully extended position. Tilt the vehicle until the
sidestand is resting on the ground.
To put the sidestand in its “idle position” (horizontal), tilt the vehi-
cle rightwards.
Before riding, make sure the sidestand is idle.
Check the spring holding the sidestand in place on a regu-
lar basis.
Do not sit on the vehicle with the sidestand operated.
SIDESTAND