31
After the “GROUND” adjustment is
made “GROUND” button is pressed and
when the light in the middle goes off the
device is ready for exploration.
The detector head of the device is lifted 40 cm above ground and
reset.
Hold the detector head 5-10
cm above and parallel to the
ground. You can explore by
moving the detector head slowly
with a right o left sweeping
motion or by walking straight.
Try to detect a target by
exploring his way. When the
device detects a metal it gives a
sound alarm and “METAL and
MINERAL” lights turn on the
screen according to the power
of the signal. When the device
detects a void it gives a sound
alarm
and
“VOID
and
MINERAL” lights turn on the
screen according to the power
of the signal.
If our target is metal or void the device gives light and sound signals.
When an alarm is received from the device over any point; the
device is taken away from the target and reset in an area where no
signal is received and the detector head is passed over the same target
again. If “CAVITY and MINERAL” lights turn on it means that our target is
a void. If “METAL and MINERAL” lights turn on it means that our target is
a metal. Resetting is repeated if necessary and the detector head is
passed over the same target again. This last operation is carried out to
make sure of the target.
Summary of Contents for JEOHUNTER 3D Dual System
