20
Utilization of the LED Switch and Lighting Principles of the LEDs:
“LED” switch is used for adjusting the
level of illumination. The device is
designed for day and night use. The
illumination level may be adjusted to
the maximum by using this switch and
enable the lights to be visible even
under sunlight. At the same time if
desired the lights may be turned off
completely. LED key is pressed after
the device is turned on to adjust the illumination level. When this key is
pressed the LED in the middle is lit to indicate that it is in LED mode.
After pressing the LED key the level of illumination is adjusted by
pressing “+” and “-“ keys. After the illumination level is set “LED” key is
pressed again to switch to Explore mode.
ATTENTION: In the LED system if
“LED,
SOUND,
SENSITIVITY,
GROUND” sections are selected, the
light in the middle is lit to inform the
operator that the device is not in
Explore mode but in one of the
above mentioned modes. To switch
back to Explore mode the key that
corresponds to the latest mode is
pressed, the light goes off and the Explore mode is active.
GROUND
“Large Void LED” and Large Metal LED” on the Joystick
never lights on in this mode.
EXPLORE
In case there is a signal strong enough to light at least
two of “Void and Mineral” LEDs on the Joystick, “Large Void LED” lights
up in this mode.
EXPLORE
In case there is a signal strong enough to light at least
two of “Metal and Mineral” LEDs on the Joystick, “Large Metal LED”
lights up in this mode.
EXPLORE
In case a precious metal is detected two precious LEDs
light on the joystick in this mode.
Summary of Contents for JEOHUNTER 3D Dual System
