Maintenance Manual
MAN-00
135
GENIO DC
(BS-III & BS-IV)
JULY 2011
/Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications
,
current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of
or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution
© 2011 Mahindra & Mahindra Ltd.
48
Refer above illustration –
1.
Keep the vehicle at a distance of
10 meter
from the black screen in the dark room.
2.
Mark the
–1.3%
height on the board as shown. i.e.
130mm
below the Headlamp centre
height.
3.
Set both LH & RH headlamp by setting the cut-off pattern at a height marked on the
board/screen.
4.
Check the function of system, by operating the switch 0 to 1 and observe the cut-off
pattern movement in down word direction accordingly.
5.
At zero position of switch the cut-off should come at
–1.3%
heights on screen
.
NOTE:
1.
Head light centre height for GENIO is
860
±
30mm.
2.
‘h’
is the height
130mm
below the HL-centre height i.e
. –1.3%
setting of cut-off pattern.
So here
h (cm)
is
73 cm/ 730mm
.
3.
Distance of vehicle from black board is
10 meters.
Head Light Aiming – Dark Room Layout
