Maintenance Manual
MAN-00
135
GENIO DC
(BS-III & BS-IV)
JULY 2011
/Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications
,
current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of
or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution
© 2011 Mahindra & Mahindra Ltd.
24
705-MAT-0221 : 0.10 hrs.
PROPELLER SHAFT SLIDING JOINT - LUBRICATE
Grease Grade
–
MAXIMILE LCG, NLGI 2/3
Park the vehicle on level ground/2 post lift /4 post lift
Always use recommended grease only.
Propeller shaft sliding joint to be lubricated at every 10000kms.
Before undercoating a vehicle with any under body protection; the propeller
shaft and the UJs should be covered. This will prevent the undercoating from
causing an unbalanced condition and vibration.
Split Type Propeller Shaft
Differential Oil – Replace
(Refer illustration/ sample sketch shown)
1.
Inspect the Sliding yoke for Grease & play; fill the grease through the grease nipple
with pressurized gun. Refer illustrations, grease nipples are shown by arrow marks.
2.
Inspect the Universal Joint for play.
3.
Check & torque tight the Companion Flange Nuts at both Transmission as well as Axle
end with –
23.5 ±3.5 Nm
.
Refer below illustrations for grease pin locations on each UJ.
Propeller Shaft Front end - Yoke
Propeller Shaft Rear end - Yoke
