9
ASSEMBLY
F) REAR HITCH ASSEMBLY
1)
Install the hitch (item 1) to the intermediate hitch
bar (item 2) using two hex. bolts 3/8" n.c. x 3" (item 3)
and two nylon insert lock nuts 3/8" n.c. (item 4).
2)
Install the rear hitch bar (item 1) on the
intermediate hitch bar (item 2) with one hex. bolt 1/2"
n.c. x 3 1/2" (item 3) two flat washers 1/2" hole (item
4), the sleeve (item 5) and one nylon insert lock nut
1/2" n.c. (item 6).
Do not tighten firmly as to let the hitch privot.
CAUTION
PINCH POINT
TO PREVENT INJURIES:
Manipulate with caution.
3)
Install the top link (item 1) to the hitch bars (item
A) using two hex. bolts 5/8" n.c. x 3 1/2" (item 2), four
sleeves (item 3) nylon insert lock nut 5/8" n.c. (item
4).
4)
Adjust the top link (item 1) to 13 1/2 inches center
to center.
5)
Install the cable holder (item 1) on the intermediate
hitch bar (item A) with the U
-
bolt and plate (item 2)
and two nylon insert lock nuts 1/2" n.c. (item 3).
NOTE:
Position the cable holder near the top link.
You may re
-
adjust this location to avoid any
interference with the control cables while towing
vehicle is in motion.
