8
ASSEMBLY
E) WHEEL INSTALLATION
NOTE:
Activate the rough cutter lift system to have a
better access with the axles support (item 2) and
ease the wheel installation.
Install the wheels assembly (item 1) on the axles
support (item 2) and secure with the cotter pin 3/16"
x 1
-
1/2" (item 3).
TIP: Once the wheels are installed, activate the lift
system will help to remove the shipping crate from
under the rough cutter.
D) INSTALLATION OF THE SPRINGS
TIP : Use a cable, hook or nylon tie wrap to extend
the spings.
Extend the springs (items 1) one at a time to install
them into the slots on the axles support (item 2).
Tighten hex. nut 3/8" n.c. (item 3) on eye bolts (item
4) using the special socket 9/16" (item 5).
NOTE:
Activate the lift mechanism of the cutter to
better position the axles support.
For instructions see section « OPERATION »
« FAMILIARIZATION WITH THE CONTRÔL BOX ».
NOTE:
When the cutter is not resting on the ground
on its wheels, the actuator’s rod may be retracted by
the spring load. This may happen with an unope-
rated actuator.
If this happens, the axles support will not be in the
best position to tighten the nuts (item 3). The solution
will then be to tighten these once the cutter in resting
on the ground on its wheels.
CAUTION
PINCH POINT
TO PREVENT INJURIES:
Manipulate with caution.
C) LIFT LINK INSTALLATION
.
Install one end of the lift link (item 1) on the lift lever
(item 2) of the rough cutter using the hex. bolt 3/8"
n.c. x 2 1/4" (item 3), the washers (item 4) and one
nylon insert lock nut 3/8" n.c.(item 5).Install the two
spacers (item 4) as shown to center the lift link (item
1) between the two lift levers.
Slightly tighten the nut.
Install the other end of the lift link (item 1) on the
axles support (item 6) by inserting the pin (item 7) into
the hole and secure with hair pin 2.5mm (item 8).
4
