6
ASSEMBLY
ASSEMBLY INSTRUCTIONS
IMPORTANT: UNLESS OTHERWISE SPECIFIED TORQUE ALL BOLTS ACCORDING TO TORQUE SPECI-
FICATION TABLE (SEE TABLE OF CONTENTS). REFER TO PARTS BREAKDOWN SECTION FOR PART
IDENTIFICATION.
Overall view
NOTE:
In this manual, the right and left side is determined being seated on the driver’s seat.
Remove all the components from the shipping crate
except the assembled rough cutter in order to help
with the assembly.
INTENDED USE
The 44” Rough Cutter is designed to clear dense
areas of grass and cut saplings in meadows and on
small estates. It is not intended to create a finish cut
on lawns. Your Rough Cutter should be towed
behind an ATV, golf cart, lawn tractor or other
approved vehicle with the help of a 2’’ (50mm) reach
ball hitch. It is not recommended for speeds
exceeding 5 mph (8 km/h) .
Tools needed:
Ratchet
Wrench : 7/16”, 1/2”, 9/16”, 3/4”, 15/16”
Socket : 7/16”, 1/2”, 9/16”, 3/4”, 15/16”, 3/8”
Pliers
WARNING
THIS ACCESSORY IS HEAVY!
To avoid risk of strain injury, NEVER lift the
accessory by hand alone when handling the
components or assembly. Use proper lifting
device and seek assistance.
When accessory is off the ground, NEVER be
underneath the accessory. Serious injury
including possibility of death could occur if
accessory were to drop suddenly.
Always wear protective shoes and appropriate
gloves when manipulating or using this
equipment.
Always make sure to wear the appropriate safety
equipment required (glasses, muffs, mask…).
