Maguire Products Weigh Scale Blender WSB, Operation & Maintenance Manual

Page: 46 / 99

M A G U I R E P R O D U C T S , I N C .
Edition: August 6, 2014
46
W E I G H S C A L E B L E N D E R
®
While in one COMPONENT list, press the Next and Previous (PREV) buttons (MATERIAL 1, MATERIAL 2, etc) to
jump to the same relative position in the next list. This allows rapid scanning of like parameters in all component
groups.
To change a displayed parameter use the up/down arrow keys to set a new number. Cancel will cancel a number
entry. Press Save to save the change. The purpose of each parameter is explained in detail in the following section.
EXIT will exit the sequence at any time.
Navigating and Making Changes to Parameters:
If Blender is running press
STOP
and wait for cycle to end:
Press
OPTIONS
Display will say:
ENTER PASSWORD
Press
then, press Enter
Display will show menu options
To alter a PARAMETER:
Press
PARAMETERS
Parameters are divided into 6 categories. Control Times, Vibration
Control, Weight Limits, Components, Regrind Control, and Mixer
Control.
Press
The category that would
contain the parameter you
want to adjust.
Categories will have several parameters indicated by a 3-letter
acronym. The Components category will have 12 materials, each
with several controlling parameters or groups of parameters.
Press
The parameter that you
want to adjust.
Display will show 5 digits. Press the up or down arrows to adjust.
Press
SAVE
To save your adjustment.
Press Until you return to the Main Screen.
General Parameters
200 series settings shown as example settings
DLY 00488 CYCLE START DELAY - Delay before cycle start. (Interrupts)
This parameter is the time that the sensor must be uncovered before a cycle will begin.
DTI 00006 WEIGH BIN DUMP TIME at end of cycle. (Seconds)
This parameter times how long the weigh bin dump valve opens to empty. No change is required.
STL 00122 DISPENSE SETTLE TIME before a weight reading is taken.
The time (interrupts) allowed for material to SETTLE in the weigh bin before a weight is taken.
Lengthen only to slow the next cycle start, thereby lowering the pile of material in the mix chamber,
and, in some cases, improving mixing.
SBO 00000 SENSOR BLOW OFF (Pulse Length, Pulse Delay)
If SBO is set to a value, the Weigh Scale Blender will pulse the Sensor Blow Off valve by a
specified pulse count and specified delay in between pulses for the purpose of clearing dust
and particles from the face of the sensor.
KDF 00010 STABLE WEIGHT - Maximum variation in GRAMS between two consecutive weight
WDF 10010 STABLE WEIGHT TARE - Readings for reading to be accepted. (x or x.x)
KDF controls sensitivity of weight readings during calibration of load cells. No change is required.
WDF controls the sensitivity of weight readings during normal operation. If excessive vibration
interferes with weight readings you may have to increase this number.