Maguire Products Weigh Scale Blender WSB, Operation & Maintenance Manual

Page: 45 / 99

M A G U I R E P R O D U C T S , I N C .
Edition: August 5, 2014
45
W E I G H S C A L E B L E N D E R
®
Parameters Introduction
Parameters –
All WEIGH SCALE BLENDER controllers operate according to certain internal PARAMETERS.
Because customer requirements vary widely, we have made a wide range of parameters accessible for change
through the touchscreen. Parameters are grouped into the following categories: Control Times, Vibration Control,
Weight Limits, Components, Regrind Control, Mixer Control.
BRIEF
explanations are given first.
FULL
information is given in the section that follows.
Parameters values shown here are initial ROM values of a model 940. Initial values for
other models are listed at the end of this section.
Parameters are five digits, with leading zeros added.
TIMES
TIMES are expressed as seconds, minutes, or interrupts.
(244 interrupts = 1 second).
WEIGHTS
are always expressed as GRAMS.
100 and 200 models use tenths of grams: (xxxx.x). (00010 = 1 gram)
400/900/1800/3000 models; full grams: (xxxxx). (00010 = 10 grams)
PERCENTS
are expressed in tenths for settings (0xxx.x), and full percents for other percentage
references (00xxx).
Navigating Parameters
Parameters are accessible from the main screen by pressing “Options”. Enter password (22222 by
default). Press “Parameters”. Parameters are grouped into the following categories:
Control Times
DLY Delay Cycle Start (milliseconds)
DTI Weigh Bin Max Empty (seconds)
STL Settle Time Before Weight Reading (milliseconds)
SBO Sensor Blow Off (pulse count, pulse delay)
Vibration Control
KDF Calibration Weight Reading Difference (1/10
th
gram)
WDF Operation Weight Reading Difference (1/10
th
gram)
BER Bailout Weight Limit (1/10
th
gram)
FUL Full Batch Weight (grams)
MAX Maximum Bin Capacity Limit (grams)
TH Tare Weight Upper Limit (1/10
th
gram)
Weight Limits
TL Tare Weight Lower Limit (1/10
th
gram)
RP Retry Limits – Allowed Percent Short
RD Retry Limits – Allowed Weight Short (1/10
th
gram)
AL Retries Before Alarm
LA Lag Time (milliseconds)
WT Dispense Rate – Weight in 1/10
th
of grams
TI Dispense Rate – Time in milliseconds
PO Pulsed Output / Timing (seconds)
SE Upper Limit
XT Format of decimal location 10ths or 100ths of grams
Components
MATERIALS 1 thru 12:
NC Limit Adjustment
ROC Regrind % to treat as Natural
ROV Regrind Level Control
Regrind Control
RHL High / Low Level Control
Mixer Control
MIX Mix Time
JOG Jog Time
MPO Air Drive Mixer Timing
FCV Flow Control Delay Open