Maguire Products Weigh Scale Blender WSB, Operation & Maintenance Manual

Page: 17 / 99

M A G U I R E P R O D U C T S , I N C .
Edition: August 5, 2014
17
W E I G H S C A L E B L E N D E R
®
Check Out Procedure
As you go through this procedure, if WHAT SHOULD HAPPEN, doesn't happen, see next section,
DIAGNOSTICS, for what to check.
MB/100/200 series models (3K load cells), display all weights in 1/10 grams (xxxx.x).
400/900/1800 series models (10K load cells) display weights in FULL grams, NO decimal point
(xxxxx). On this page we show all weights with NO decimal point.
Start with NO MATERIAL in any hoppers.
Be sure an AIR SUPPLY is connected.
Turn POWER SWITCH OFF (on side of Power Box).
PROCEDURE: WHAT SHOULD HAPPEN:
1. POWER UP CONTROLLER / Blender
PLUG IN CONTROLLER
Nothing should happen.
Air pressure should be holding ALL valves CLOSED.
This means all air cylinders are extended. If any slide gate or flap is
open, air lines are reversed.
If a FLOW CONTROL VALVE is installed, check it.
TURN POWER ON
Display should briefly show a screen:
POWER-ON SELF-TEST
This screen with display the following information:
Model, Serial Number (SN), Software,
Firmware, Time, Date.
Then the Screen will display the Main
Touchscreen view, which includes a
“Main Display” displaying the actual
weight of material in the bin. This
number should be zero, plus or minus
several grams ( 20) to (-20).
AT THIS POINT
Be sure the model number that displays matches your blender model
number. If this is not the case see two sections ahead, SELECTING
CORRECT MODEL.
TOUCH WEIGH BIN VERY LIGHTLY
Display should update the weight every second reflecting the light
pressure that you are exerting on the bin.
2. OPERATE DISPENSE DEVICES
PRESS
OPTIONS
Display will say
ENTER PASSWORD
PRESS
then, press Enter button
This enters the PROGRAM mode. Display will show a menu of
options.
PRESS
MANUAL OPERATION
Display will say
OPERATE DEVICES
PRESS
MAT 1
Device number 1 will operate.
Press "1" repeatedly to observe operation.
PRESS
MAT 2
Device number 2 will operate.
Press "2" repeatedly to observe operation.
REPEAT THIS SEQUENCE
For each dispense valve on your WEIGH SCALE BLENDER.
Up to 12 outputs are possible numbered
MAT 1
through to
MAT 12
.
Only those connected to devices will operate.