Maguire Products Weigh Scale Blender WSB, Operation & Maintenance Manual

Page: 18 / 99

M A G U I R E P R O D U C T S , I N C .
Edition: August 6, 2014
18
W E I G H S C A L E B L E N D E R
®
3. NOTE HOPPER NUMBERS
AT THIS POINT
NOTE which component NUMBER is assigned to each hopper.
You will want to know each hopper's correct component number.
FOR WSB 940 & WSB
1840 SERIES:
On 9000 and 18000 gram, FOUR hopper compartment systems, facing the
Controller side of the blender:
Device 1 is the NEAR hopper, 2 the FAR hopper, 3 the LEFT CENTER, and 4 the
RIGHT CENTER hopper.
FOR WSB 100, 200 &
400 SERIES:
On 1000, 2000, and 4000 gram, FOUR hopper systems facing the Controller side of
the blender:
Devices 1, 2, 3, and 4 are counter-clockwise starting with far left corner hopper.
FOR WSB 200, 400, 900
& 1800 SERIES:
On 2000, 4000, 9000 and 18000 gram SIX hopper systems facing the Controller side
of the blender:
Devices 1, 2, 3, 4, 7, and 8 are counter-clockwise starting with far left corner hopper.
FOR WSB 100, 200,
400, 900 & 1800
SERIES:
On the blender Controller:
Device 5 is the LEFT Panel-front OUTLET.
Device 6 is the RIGHT Panel-front OUTLET.
4. OPERATE OTHER DEVICES
PRESS
DUMP
The weigh bin air solenoid will operate.
The weigh bin dump valve will open.
Press, "DUMP" repeatedly to observe operation.
PRESS
MIX
This key controls the mix motor outlet on the side of the controller.
The mixer motor will run.
Mix blade turns clockwise facing the motor shaft or 270º on Pneumatic Mix Motors.
Mixer switch must be down; timed position.
PRESS
HOLD
The Flow Control Valve will operate.
(Under the mix chamber - this device is optional)
PRESS
ALARM
The Strobe light and Beeper will operate.
Display will show
ALARM: ON
PRESS Press twice, to return to normal mode.
Verify normal mode by observing that the display is back to the Main Touchscreen
display.
If you have made it this far, congratulations. You have done well.
The load cells and controller are functioning properly.
LOAD CELL CALIBRATION – SKIP TO PAGE 27