Maguire Products Weigh Scale Blender WSB, Operation & Maintenance Manual

Page: 15 / 99

M A G U I R E P R O D U C T S , I N C .
Edition: August 5, 2014
15
W E I G H S C A L E B L E N D E R
®
2. Slide the WEIGH BIN into position.
It rests behind the clear-hinged access window.
Install with the air cylinder toward you. If bin is already in place, remove any shipping
materials, packing tape or string.
3.
Hang the Color and Additive Feeders: (Optional)
a. Lift side latches and fully extend slide assembly. Remove the hopper. Leave slide
extended.
b. Tilting the entire slide assembly, motor end up, insert one corner of hanger cross bar behind
frame corner post.
c. Rotate assembly into place so both ends of cross bar are behind corner posts.
d. Lower into place, bottom edge resting on frame and cross bar properly positioned behind
corner posts.
e.
Re-install hopper. Slide motor forward until latches engage.
4. Connect the Touchscreen to the mounting wing and plug in Touchscreen cable
(7-pin connector).
5. Plug the power cord coming from the power box into a 110-volt power source
(220 volt outside USA).
This cord MUST provide the ONLY power source for the
entire system, including the controller. See: WIRING CONSIDERATIONS, next page.
1800 series blenders also require a 240-volt power source for the mix motors.
6. Connect Compressed Air to the unit.
About 80 psi (5.5 bar) is recommended (40 psi
for the Micro Blender). Lubricated air is NOT recommended.
NOTE:
Micro Blenders should be set to 40 psi (2.7 bar). The
Vertical Valves used in removable hoppers on Micro Blenders
are more accurate at the lower 40 psi pressure setting.
7. Remove all protective paper from the plastic windows.