13
Connecting the Device
3-1 Installation
3.1.1 Connecting the Device
Connection to the power supply
The device must be connected to a properly protected and grounded socket outlet.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
1. Connect the power cable to the power supply unit, then plug the power supply unit connector into
the device.
2. Plug the end of the power cable into a grounded power socket.
3. The device is powered on: the control panel lights up showing the device is working properly. If the
control panel does not light, then either installation has not been carried out correctly or the device
is not working properly. Check the installation.
Before attempting any maintenance, ensure that the power cable is always unplugged. For your personal safety, ensure that the cable and
power supply unit remain easy to access, especially in the event of an emergency.
To save energy, the device will automatically switch itself to standby mode after 10 minutes of inactivity. The device switches to hibernation
mode after 30 minutes in standby mode.
The standby times can be configured in the MagTek Print Driver. In standard standby mode, sending a print request restarts the device and
quickly pressing on the button for 1 second exits the device from hibernation mode.
Connecting the USB cable
Under no circumstances should you connect the USB data cable before installation of the device driver is complete.
Refer to the section on device driver installation for further details, and follow the instructions carefully.
3