OPERATION
43
To adjust the temperature of the air coming out of the
air vents use the
+
and
-
buttons under the air
temperature indicator
3
.
To adjust the air flow from the vents use the
+
and
-
buttons under the air flow rate indicator
4
.
In case of contamination of the outside air,
recirculation of the internal air can be activated.
To activate or deactivate internal air recirculation
press button
2
.
The indicators do not express the temperature or flow
rate values but only reference numeric values.
Work lights
Button
1
activates the orange beacon that indicates
that the vehicle is in motion.
Buttons
2
,
3
and
4
activate the lights at the top of the
boom, those on the front of the cab and those at the
rear of the cab, respectively.
Telescopic boom suspension (optional)
This button is present if the optional concerned is
present on the forklift truck being used.
The telescopic boom suspension is designed for
operating the vehicle on uneven ground with loads
raised.
To use this function the following conditions must be
respected:
-
vehicle on wheels;
-
turret in central position;
-
telescopic boom height from the ground less than
3 metres;
To activate/deactivate the telescopic boom suspension,
press the button in the commands page shown above.
Wait for the relevant indicator to light up or be switched
off in the main page of the display to confirm the
required selection.
The boom suspension only works in the presence of
the afore-mentioned conditions: if said requirements
are not satisfied during a movement, the function is
automatically disabled; if, with the forklift truck
moving, the parameters required fall within the
envisaged
limits,
the
boom
suspension
is
automatically reactivated.
When the forklift truck stops, the function is
deactivated; to reactivate it repeat the procedure
described above.
Checking the engine rpm
The button indicated is used to activate or deactivate
the engine speed electronic control function: if
selected, as soon as a hydraulic movement is imparted
to a forklift truck component, the engine
automatically increases the speed to provide force to
the services pump and consequently facilitate the
movement imparted.
Activation of radio control
To operate the forklift truck externally using radio
control the receiver connection present on the vehicle
must be activated by pressing the button shown
above.
To use the radio control (OPTIONAL) refer to the
relevant Use and Maintenance Manual.
1
2
3
4
Summary of Contents for RTH 4.18
