MAINTENANCE
109
Fuel tank
Refuelling
Set the vehicle in the parking position. Switch the
engine off.
Unlock the tank cap using wrench
1
. Unscrew the tank
cap by turning it anti-clockwise.
Refuel using suitable fuel. Screw the fuel cap in and
lock using wrench
1
.
For drive units complying to Stage IV and stage V
regulatory standards use only fuels with low sulphur
contact, as indicated on the label positioned on the
side of the tank filler opening, 2.
Cleaning
Unscrew the filler cap. Place a suitably sized container
under the fuel tank near drainage cap
3
.
Unscrew drainage cap
3
, and drain out the tank
completely.
Pour 10 litres of clean fuel into the tank to rinse out
impurities that may be present at the bottom.
Close and tighten drainage cap
3
. Fill the tank with
clean fuel. Check to make sure there are no leaks.
Window washing liquid tank
Filling
Open the compartment in the rear part of the cab to
access the window washing liquid tank housing.
Unscrew the cap by turning it anti-clockwise. Fill the
tank with window washing liquid, leaving about 1 cm
between the liquid level and the edge.
Refit cap
1
and tighten it by hand.
Hydraulic hoses
Inspection
Check the condition of the hydraulic hoses available
for a visual inspection and ensure that there are no
leaks from the connectors
1
, fittings
2
or along the
hose
3
.
If a fault is found in any of the points indicated above,
replace the hose and check the condition of the seals
on the part the hose screws onto (connector, valve,
hose).
1
3
1
2
1
2
3
Summary of Contents for RTH 4.18
