Page 34
3.9.7. Installation of Dimension Fascia Pack (Allusion)
1. Unpack the contents of the Fascia Pack.
2. Separate the door from the mounting
frame by opening and lifting the door off
of the two-part hinges as indicated in
Figure 62
. Set the door carefully aside.
3. Remove all remaining packaging from
the mounting frame.
4. Offer the mounting frame up to the
appliance opening and centralise it by
aligning the locating slots with the flange
of the box. Refer to
Figure 63.
5. Once the desired position is achieved
(level in all planes) mark the four hole
positions onto the wall, set the frame
aside, then drill and plug the marked
hole positions.
6. Having ensured all connections have
been completed, secure the mounting
frame to the wall.
7. Re-hang the door and check for
satisfactory operation.
8. For Manual Control models, proceed to
Section 3.9.12
to commission the
appliance.
9. For other control options, proceed to
Section 3.9.8
to
3.9.10
(Continuation of
installation) as applicable.
The fascia
mounting frame
must be flat and level in all
directions when fitted. Failure
to ensure this will result in
poorly fitting fascia. Suitable
material may be used behind
the frame fixing points to level
it.
Fixing
Points
Mounting
Frame
Fascia
Door
Figure 62
Locating Slots
Figure 63
Fascia
Mounting
Frame
Appliance Box
Burner Tray
Figure 64
