Page 16
6. Next place the two
J
driftwood pieces
and the
K
,
D
and
C
pebbles as in
Figure
34
.
7. Continue laying the driftwood pieces and
the pebbles as shown in
Figure 35
to
Figure 37
.
8. After the appliance has been allowed to
warm up, small adjustments (using a
small pair of tongs) may be made to the
top layer to achieve the desired flame
picture.
9. It is recommended that the pebbles and
driftwood be left alone once the desired
flame pattern has been achieved.
Constant moving of the pebbles and
driftwood causes them to disintegrate
and/or cause discolouration
.
WARNING:
Do not touch the
fire when it is alight. The fire
will remain very hot for a while
after extinguishing.
K
D
C
J
J
Figure 34
B
L
K
Figure 35
C
D
D C
C
A
Figure 36
E
C
A
J
C
E
J
Figure 37
Some sooting on the fuel effect may be observed. This is perfectly normal.
Periodically operating the fire at various rates will burn this soot away. If
excessive sooting is observed, this is an indication that the fuel bed is laid
incorrectly – please refer to instructions.
