Page 33
3.9.6. Installation of Pure/Form Fascia Pack (Affinity)
1. Unpack the contents of the Fascia Pack.
2. Separate the door from the mounting
frame by opening and lifting the door off
of the two-part hinges as indicated in
Figure 59
. Set the door carefully aside.
3. Remove all remaining packaging from
the mounting frame.
4. Referring to
Figure 60
,
fold the three
locating tabs backwards.
5. Offer the mounting frame up to the
appliance opening, taking note of the
locating tab projecting to the rear of the
mounting frame as shown in
Figure 61
.
6. Insert the locating tab (identified in the
step above) into the top of the appliance
opening. This facility has been designed
to assist in setting the correct height and
centralising the mounting frame.
7. Once the desired position is achieved
(level in all planes) mark the four hole
positions onto the wall, set the frame
aside, then drill and plug the marked
hole positions.
8. Having ensured all connections have
been completed, secure the mounting
frame to the wall.
9. Re-hang the door and check for
satisfactory operation.
10. For Manual Control models. Proceed to
Section 3.9.12
to commission the
appliance.
11. For other control options, proceed to
Section 3.9.8
to
3.9.10
(Continuation of
installation) as applicable.
The fascia
mounting frame
must be flat and level in all
directions when fitted. Failure
to ensure this will result in
poorly fitting fascia. Suitable
material may be used behind
the frame fixing points to level
it.
Fixing
Points
Lift Off
Hinges
Fascia
Door
Figure 59
FOLD BACK 90
O
Locating Tabs
Figure 60
Fascia
Locating Tab
Appliance Box
Burner Tray
Figure 61
