Page 29
3.9. Installation
Procedure
Before commencing installation, ensure that the intended installation will comply
with details in
General Information
on Pages
1
and
21
.
Carefully unpack the contents of the carton and check them against the checklist given on the
previous page.
Make sure that the fireplace opening is suitable for the installation of the fire and prepare the
fireplace to suit the dimensional requirements given in
Section
3.6
(i.e. fitting the fire
surround, the hearth (if required) etc.).
3.9.1. Initial Installation of Pure Additions Fascia (if applicable)
If a fascia from the Pure Additions range has been supplied, at this point refer to the
supplementary leaflet for preparatory work.
Some examples of the Pure fascia Additions range that are supplied with additional
instructions are: Pure Reveal; Pure Reveal Luminaire; Pure Eclipse; Pure Contour.
3.9.2. Preparing the Firebox
1. Remove the two burner fixing screws
located under the front corners of the
tray (see
Figure 40
to
Figure 41
on
page
23
).
2. Withdraw the burner from the firebox,
taking care not to damage the ceramic
back and side panels. Place the burner
away for later use.
3. Apply the foam sealing strip all round the
rear edge of the firebox flange by
removing the protective backing paper
(see
Figure 53
).
4. Unpack the cable fixing kit and feed the
cable ends through the top holes on the
sides of the flue outlet (see
Figure 54
).
Seal
Figure 53
Cables
Figure 54
