UNLOADING AND ASSEMBLY
Form # 169080
Model Year - 2010
35
e. Remove four bolts (B) and remove inboard
hourglass driven deflector (C).
f. Locate feed pate (D) on the disc ensuring that
hole in feed plate registers on disc. Position
plate as shown and align holes.
IMPORTANT
Feed plate should be located so that
when holes are aligned, the leading
edge of the feed plate (D) is further from
the accelerator (E) than the trailing edge.
.
NOTE
Older type feed plates may required
trimming to properly locate on disc. Locate
feed plate (D) on disc and scribe a trim line
on feed plate to clear the accelerators (E).
Trim feed plate to suit.
g. Re-position deflector (C) and align hole s.
h. Re-install bolts (B) and tighten to 92 ft·lbf (125
N·m).
i.
Repeat above steps for opposite side.
j. Manually rotate discs to check for interference of
feed plate and adjacent parts.
B
C
CLOCKWISE ROTATION
LH INBOARD DISC
D
LEADING EDGE
E
D
LEADING EDGE
COUNTERCLOCKWISE ROTATION
RH INBOARD DISC
E
B
C
D
E
COUNTERCLOCKWISE ROTATION
RH INBOARD DISC
