UNLOADING AND ASSEMBLY
Form # 169080
Model Year - 2010
32
d. Install two 3/8 x 1.0 lg. (E) bolts and nuts in
holes at corners but do not tighten.
e. Install two ½ x 1.0 lg. bolts (F) and nuts on
each side. Nuts on outside. Do not tighten.
f. Install ten 3/8 x 0.75 lg. bolts, 3/8 ID x 1¼ OD
x 1/8 THK flatwashers and nuts at support
locations (D). Install with nuts on top side and
washers between nut and top cover.
g. Lift aft end of forming shield so that side deflectors
clear float springs and tighten all bolts.
h. Remove bolt and nut at two places and discard.
i. Retrieve hardware as supplied and install ½ x
1.75 lg. bolt (G) from underneath, washers (H),
rubber washer (J), and handle (K) as shown at 2
places.
(continued next page)
H
J
K
G
F
D
D
E
