UNLOADING AND ASSEMBLY
Form # 169080
Model Year - 2010
25
e. The measurement must not exceed the
following:
DRIVELINE SHAFT SIZE
DISTANCE ‘X’
1.375 in. (34 mm)
14 in. (356 mm)
1.75 in. (43 mm)
17 in. (432 mm)
f. Change locations of pins (N) in APT arms to
hole (O) to locate implement closer to tractor if
necessary.
g. Position mower conditioner driveline (P) onto
tractor PTO shaft. Driveline should be
approximately level.
h. Pull back collar on driveshaft and push
driveshaft until it locks. Release collar.
i. Rotate driveline storage hook (Q) to upward
position.
j.
Attach down-stop chains (R) to pin (S) on tractor.
CAUTION
The downstop chains limit the downward
travel of the 3-point hitch lifting arms to
prevent damaging the PTO driveline on the
mower-conditioner. Ensure chains are
attached when operating the mower-
conditioner.
k. Adjust chain length as required by relocating end
link at tractor end of chain as follows:
1. Remove cotter pin and clevis pin (T) to
disconnect open link (U) and end link (V).
2. Relocate open link (U) to new location on
chain and re-attach to end link (V) with clevis
pin (T). Chains do not need to be tight.
3. Secure clevis pin with cotter pin.
(continued next page)
P
Q
V
T
U
N
O
S
R
