MacDon HC10, Setup, Operation, And Parts Manual

Page: 52 / 186

215593
42
Revision A
3.9 Installing the Forming Shield
The forming shields attach to both the HC10 and the windrower.
$
%
Figure 3.60: Forming Shield and HC10
1. Position the forward end of forming shield (A) onto two
pins (B) located on the rear cover of the conditioner.
$
Figure 3.61: Lynch Pin
2. Insert lynch pins (A) to secure forming shield to conditioner.
$
%
&
'
Figure 3.62: Forming Shield
3. Set forming shield side deflectors to desired width by
loosening handle (A) and moving deflector (B). Set
deflectors on both sides to approximately the same
position.
4. Tighten handles (A).
5. Loosen handles (C) and adjust fluffer shield (D) to middle
position.
6. Tighten handles (C).
UNLOADING AND ASSEMBLY