MacDon HC10, Setup, Operation, And Parts Manual

Page: 42 / 186

215593
32
Revision A
&
$
'
(
%
Figure 3.37: Lifting Arm
–
Left Side
27. Place lifting arm (A) into storage position as shown.
28. Reattach lift arm (A) to bracket (B) using nut and bolt (C).
Leave hardware loose.
29. Secure lifting arm using L-pin (D).
NOTE:
Rotate pin (D) to align the key-hole slot.
30. Tighten hardware (E) to secure bracket (B) to the
conditioner. Tighten hardware (C) to secure lift arm (A) to
bracket (B).
31. Repeat Steps 6, page 30 to 24, page 31 for the other
lifting arm.
$
Figure 3.38: Conditioner
–
Right Side
32. Retrieve the following parts from the loose parts package
shipped with MD #B4799:
•
Two 5/8 in. flange nuts
•
Two 5/8 in. x 1 1/2 in. carriage bolts
Install one 5/8 in. flange nut (A) and one 5/8 in. x 1 1/2 in.
carriage bolt in the lower right attachment location.
$
Figure 3.39: Conditioner
–
Left Side
33. Install one 5/8 in. flange nut (A) and one 5/8 in. x 1 1/2 in.
carriage bolt in the lower left attachment location.
UNLOADING AND ASSEMBLY