MacDon HC10, Setup, Operation, And Parts Manual

Page: 25 / 186

215593
15
Revision A
Chapter 3: Unloading and Assembly
To unload and assemble an HC10 Hay Conditioner, follow each of the procedures in this chapter in order.
3.1 Unloading the Hay Conditioner
To unload machines from a shipment safely and without damage, understand the weight limits and lifting requirements,
and familiarize yourself with the procedure.
Figure 3.1: Hay Conditioner Bundle (MD #B4798)
CAUTION
To avoid injury to bystanders from being struck by machinery,
do NOT allow people to stand in unloading area.
CAUTION
Equipment used for unloading must meet or exceed the
requirements specified below. Using inadequate equipment
may result in vehicle tipping or machine damage.
Table 3.1 Lifting Vehicle Requirements
Minimum Lifting Capacity 4 908 kg (2000 lb.)
Minimum Fork Length 1524 mm (60 in.)
Figure 3.2: Feed Deck Bundle (MD #B4799)
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.)
ahead of the back end of the forks. Check with your forklift
distributor to obtain the forklift capacity at 1220 mm (48 in.).
WARNING
Be sure forks are secure before moving away from load. Stand
clear when lifting.
4. At 1220 mm (48 in.) from back end of forks.