MacDon HC10, Setup, Operation, And Parts Manual

Page: 32 / 186

215593
22
Revision A
3.4.2 Installing HC10 Mounting Brackets
–
D60, D65, and D130
Bolt-on mounting brackets are required to connect the HC10 to D60, D65, and D130 headers.
$
%
Figure 3.14: Lower Deck Brackets
1. Retrieve the following parts from the loose parts package
shipped with MD #B4799:
•
Left lower bracket (MD #130817)
•
Right lower bracket (MD #130831)
•
Two 1/2 in. flange nuts (MD #50186)
•
Two 1/2 x 1 1/4 in. carriage bolts (MD #21471)
Install lower brackets (A) (Left: MD #130817),
(Right: MD #130831) onto the inside of both center header
legs with two 1/2 x 1 1/4 in. carriage bolts (MD #21471)
and two 1/2 in. flange nuts (B) (MD #50186) in each
bracket.
$
%
(
&
'
Figure 3.15: Upper Bracket
–
D60/D65 4.6 m (15 ft.)
Header Shown
2. Retrieve the following parts from the loose parts package
shipped with MD #B4799:
•
Right upper bracket (MD #130803)
•
One spacer (MD #159700)
•
Two 5/8 in. flange nuts (MD #50225)
•
One 5/8 x 7 1/2 in. hex bolt (MD #135906)
Install right upper bracket (A) (MD #130803) and spacer (B)
(MD #159700) on the right center leg as shown in the
illustration, and install one 5/8 in. flange nut (C)
(MD #50225).
NOTE:
On headers with a sheet metal hose cover, install bolts from
the outboard side.
3. Install 5/8 x 7 1/2 in. hex bolt (D) (MD #135906) through
the bracket and spacer and secure it with one 5/8 in. flange
nut (E) (MD #50225).
4. Tighten both nuts (C) and (E).
UNLOADING AND ASSEMBLY